KEY WEST PS030 REGULATOR / RECTIFIER

20 025
Арт.
11-03168
Описание

Advanced regulator/rectifier circuit provides steady 13.8 volt output regardless of load. Maximum output 220 watts, 16 amps. Accepts AC input from 15 to 100 volts. Can be used with AC strobe.

Features
  • Extremely clean filtered DC output
  • Electronics designed to deliver 16 amps producing 220 watts
  • Efficiency: No "consumer" or "dummy" load required for proper operation
  • A beautiful and rugged lightweight package weighs just 16 ounces and is 3.5 x 2.5 x 1 inch
  • Protection from the environment: complete epoxy encapsulation to insure all-season operation
  • Ease of installation: crimp type ring terminals and wiring schematics provided with every unit

Отзывы Оставить отзыв

Отзывы ещё не добавлены

Вопросы и ответы
Can these regulators be used on the Jabiru engine? The Jabiru has a permanent magnet rotor.

Per the supplier: No, it will not work on the Jabiru's.

Will this work on the Rotax 503?I think it can put out 150 volts AC and I see this one says up to a 100 volts.

Per Vendor: Yes, the Rotax 503 would be the most typical application for this product. This will be hooked up to the lighting coil/alternator.

I have a Rotax 503 installed on my flightstar I am running the consumers with a battery but no electric starter. Will this regulator overcharge a 12V nine amp battery?

No, this would not over charge your battery, as long as your battery is not over 14 Volts.

Would this KEY WEST PS030 REGULATOR / RECTIFIER be suitable for a Rotax 582 with an electric starter motor?

Yes, the Keywest regulator is a very popular regulator for Rotax 2 stroke engines.

Rotax 447: Can this regulator be used with a 12v, 10-14amp sealed battery without causing an overcharging condition?

Per Rotax Tech: Yes, this regulator will work fine.

How many input watts can this handle? Im thinking of hooking up both my tachometer coil and lightning coils to it for 130-160watts

Max input is 220 watts.

Will this work in a Rotax 532 points ignition?

Per Vendor: if the 532 has the same "lighting coil" as the 582 then yes the 11-03168 will work. On the circa 1990-2000 Rotax 503 and 582 engines these were the yellow and yellow / black wires coming out if the flywheel case.