STEWART SYSTEMS EKOBOND

20 025 ₽

Описание

With Heat Pack option adds a shipping heat pack to keep the material from freezing while in transit. It is recommended for winter months / destinations in cold climates where the temperature may drop below freezing while in transit. If the material freezes, it is not recommended for use.

EkoBond is a revolutionary water based cement for the application of fabric. EkoBond has extreme bond strength for fabric to fabric and fabric to non-fabric surfaces in both peel and shear tests. EkoBond is very user friendly since it has very little odor and can be used in a closed shop with open flame heat with no health or fire hazards. When dry, EkoBond will adhere to itself, making it useful as a contact cement for a variety of applications. EkoBond is EPA compliant, non-flammable, non-hazardous and low in VOCs.

Available in quart or gallon-sized containers.

Documents

09-41200msds.pdf

EkoBond%20Application.pdf

Арт.	MPN	Описание	Цена
09-41195	E610G-Q	STEWART SYSTEMS EKOBOND	$ 66.75
09-41200	E610G-G	EKOBOND CEMENT E610 GL	$ 216.95
09-41200-HP		EKOBOND CEMENT E610 GL W/ HEAT PACK	$ 231.95
09-41195-HP		EKOBOND CEMENT QT W/ HEAT PACK	$ 74.25

Отзывы Оставить отзыв

Отзывы ещё не добавлены

Вопросы и ответы

Is this Stewart Systems Ekobond cement suitable to use with Dacron fabric?

Yes, the Ekobond Cement is suitable to use with Dacron Fabric.

Is Stewart Systems Ekobond suitable for Ceconite?

Yes, the Ekobond is suitable to be used on Ceconite fabric.

Is this Stewart Systems Ekobond product heat activated?

Somewhat. None of our products are technically heat activated. EkoBond is softened by heat and that allows the fabric to be pressed down into it. But it is not activated by heat. The heat is a temporary tack to hold the fabric, the wet glue going through the fabric and drying is the true glue joint. EkoFill is similar. Heat is not necessary to apply it. It can however, be softened by heat. That is useful for pressing down tape edges with an iron. Ironing tape edges down works equally well with Ekobond or EkoFill.

Can I use Stewart Systems Ekobond over a fuselage cover with enamel paint or do I need to strip it to bare metal?

Per Vendor: E610 will adhere just fine to any paint that is clean and scuff sanded. However, it is important to remember that it is adhering to the paint. If the paint does not have good adhesion to the substrate what is bonded to it will simply come off with the paint. As long as the paint is in good condition with good adhesion, no need to remove it.