SINGLE CHANNEL PWM DIMMER NON-FAA PMA

10 770 ₽

Описание

Single Channel PWM (pulse wave modulation) dimmers are ideal for operating LED Light Strips and other interior incandescent or LED lighting, such as map lights, convenience, footwell or baggage compartment lighting. Features include reverse-polarity protection and over-voltage protection as well as an integrated on/off switch (in the fully counterclockwise position).

12 Volt DC (14VDC systems) version has 7 Amps of capacity (97W)
24 Volt DC (28VDC systems) version has 4 Amps of capacity (112W)
Just 1.25” x 1.6”. Shaft diameter is 17/64” (6.75mm)
Screw-down terminals for easy connection of input and output wires
Powerful enough to operate a wide range of lighting products
High-quality push-on knob. Shaft length accommodates panel widths to 5mm.

Арт.	MPN	Описание	Цена	Add to cart form
11-07286	24VDIMMER01B	SINGLE CHANNEL PWM DIMMER 24V	$ 35.90
11-06674	12VDIMMER01-7A	SINGLE CHANNEL PWM DIMMER NON-FAA PMA	$ 35.90

Отзывы Оставить отзыв

Отзывы ещё не добавлены

Вопросы и ответы

Can this item be used to control background lighting of radios in avionics stack?

Per the supplier: Yes, usually - it depends on the radios and the type of circuit controlling the back lighting.

What is the width x height of the Single Channel PWM dimmer behind the panel? I have a fairly tight space between two toggle switches.

1.25 x 1.6. Shaft diameter is 17/64 (6.75mm)

Does the knob include an off position, or is a separate switch required to turn off the circuit?

This unit does not have an OFF detent. When the dimmer is turned off, the power is not cut off completely, a separate switch would be required.

Is this dimmer FAA approved?

No, these dimmers are not FAA approved. Intended for use in experimental aircraft only.

The description says there is an on-off switch. A prior question indicates there is not. Which is it?

There is no distinct switch that is separate from the knob, although turning it all the way will go past the "switch" and turn it off. A gently turn past the notch the other way turns it back on.

What size hole is requires to mount dimmer?

1/4 inch.