CESSNA 180 / 182 (EARLY MODELS) BAFFLES

These baffles are FAA/PMA approved, have the silicone seals attached, and arrive ready to install. About these baffles in general:

• Baffles are made of 6061-T6 aluminum with many improvements over the original baffling.
• Improvements include: stainless steel brackets where needed, hard rivet construction, half inch backing plates on seals, and an improved fit to increase engine cooling.
• All engine baffles are designed to replace the factory installations and are individually interchangeable.
• The baffle seals are fiberglass reinforced, high temperature silicone: black is standard.
• If aftermarket components of differing dimensions have been installed, it is the installer's responsibility to adjust the baffles to fit. Sample components include: starters, alternators, exhaust, etc.
• Mounting hardware is not included (nuts, bolts, screws, washers, retaining springs, and Tinnerman clips).

If purchasing a complete baffle set, please measure you oil cooler and compare to package images A, B, C, and D to select the oil cooler package required for your airplane. This will be noted at checkout.

All baffles are bare 6061-T6 aluminum unless the powder coating option is chosen. The powder coating finish is a black and grey hammertone, and available for an additional 20%.

The silicone baffle seal material can be special ordered in orange or dark blue by calling
1-877-477-7823 or by email