P1 MOMENTARY SWITCHES

5 955 ₽

Описание

The P1 is a sealed, dustproof, snap action, military grade switch ideal for switching low level up to 10 amps. It features screw terminals, and includes screws, lockwashers, and solder lugs. MIL qualified. Dustproof, snap action, screw terminals, rugged reliable construction.

Electrical: (at 28VDC or 115VAC, 60/400 Hz.)
Load	Amperes	Life (Nominal)
Resistive	10	25,000 cycles
Inductive/Motor	5	25,000 cycles
Lamp	3	25,000 cycles

Features

Button sealed with patented “rolling sleeve” principle
Contact area sealed at button & terminals
Less than 25mΩ contact resistance
Ideal for low level switching as well as up to 10 amp duty
Positive tactile feedback

Documents

11-00749.pdf

Арт.	MPN	Описание	Цена
11-00750	P1-32129	P1 MOMEN. SWITCH P1-32129 WHT	$ 20.90
11-00749	P1-32122	P1 MOMEN. SWITCH P1-32122 BLK	$ 20.50
11-00747	P1-12129	P1 MOMEN. SWITCH P1-12129 WHT	$ 19.85
11-00748	P1-32121	P1 MOMENTARY SWITCHES	$ 19.85
11-00746	P1-12122	P1 MOMEN. SWITCH P1-12122 BLK	$ 20.95
11-00745	P1-12121	P1 MOMEN. SWITCH P1-12121 RED	$ 20.90

Отзывы Оставить отзыв

Отзывы ещё не добавлены

Вопросы и ответы

For part number 11-00745 what is the diameter size of the button press fit body and is the whole item red or just the actual button?

The diameter size of the button press fit body is 9/16"(.562") and the button is red while the body is black.

What does momentary mean? What does press fit mean? What does SPDT mean?

Momentary means you have to hold the switch down to activate it. As soon as you release the switch it turns off. Press fit means that there are no threads and simply pushes into an exact size hole. SPDT means single pole double throw. This is a switch that only has a single input and can connect to and switch between 2 outputs.

Are the two P1 switch terminal posts (or terminal flanges) marked ground & positive?Im not very knowledgeable about these matters. By the way, 1/2 was too small, I drilled a 9/16 into my airplane control yoke & wrapped a piece of scotch tape around the cylinder and the switch fit perfectly and tightly.

No, this switch can be wired in either direction.

For example, otto no. P1-12121 (spruce pn 11-00745) - according to the spec. sheet the first 2 to the right of the hyphen indicates a screw connection not a solder connection, yet your description for all these switches says they have solder connections. The otto no of this switch with a solder connection should be P1-11121. Please confirm whether 11-00745 has a solder or screw connection?

The switch has screw terminals. Included with the switch are screws, lockwashers, and solder lugs.

The item shown P1-32121 - does it require a hole of 5/8?

Yes, this requires a 5/8 mounting hole.

Any reason why this shouldnt work with a 14V system?

No, this should work fine in a 14 volt system.